R404a Recharge, R290 Recharge
New pix to be uploaded
splitter with access Valve on low side of system
Close up of splitter, with leak checking liquid on braze
Vacuum pump and gauge attached to manual valve
Close look at micron gauge
3CFM Vacuum pump
close up of Vacuum Guage
Gauge showing 100 Micron vacuum
Digital refrigeration scale, and breaking vacuum with R134a
Charging liquid R134a into Low and High side
System running with initial charge of R134a -12c
320w Peltier plate for load testing
Peltier plate mounted with hot side on Evaporator
-49C with R134a with out load
Gauges showing Low side in 13'' Mercury vacuum and high side with 66PSIG
Top view of Phase unit
-50C with R134a
Adjusting refrigerant charge for 200 watt heat load, Holding about -40C
Frost on suction line
Addition of insulation to evaporator suction line
Close up of Evaporator and suction line insulation
-49C under no load with R134a Charge
Mesh sleeving added to protect insulation from chafing
Recovery of R134a with Recovery container and Recovery pump
Pulling Vacuum with 7CFM Vacuum Pump
Charging Liquid R404 into system on high and low side. Measuring charge with electronic Refrigerant scale.
Initial charge breaks -50C and Evaporator temperature sensor bugs out.
Charging R290 into Phase unit
Voyager left Exterminator middle and BackBurn right
T7 Phase unit on table awaiting work.
Preparation of EVGA 680I mobo for Phase cooling with insulating seal string
T7 Mod up and running!
View from side with gauges
Close up view of Phase cooled QX6700 ES
T7 Phase unit used for as Koolance water chiller
Side view with panel removed
Close up of Koolance CHC 120 used for Heat Exchanger in Phase operated water chiller